Sensor (Media Eject Clamp Hp) Removal - Lexmark X940e Service Manual

7510-XXX

Sensor (media eject clamp HP) removal

1. Remove the rear upper cover. See
2. Remove the upper media bin assembly. See
3. Remove the two media eject unit springs attached to the media eject unit assembly by pushing them
downward.
4. Remove the media eject clamp motor assembly. See
page 4-65.
5. Release the hooks of the sensor (media eject clamp HP) (A) from the bracket (B).
6. Remove the sensor (media eject clamp HP) (A).
4-66
MFP Finisher Service Manual
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
Right
Springs
B
A
B
4-23.
"Media eject clamp motor assembly removal" on
4-19.