Bridge Unit Assembly Removal - Lexmark X940e Service Manual

8. Remove the two screws securing the finisher docking bracket (D) to the printer.
9. Remove the finisher docking bracket (D).
Replacement note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.

Bridge unit assembly removal

1. Release the hook securing the bridge unit hookup cover (A) to the finisher.
2. Remove the bridge unit hookup cover (A).
3. Remove the finisher from the printer.
4. Remove the two screws securing the bridge unit assembly (B) to the printer.
Boss
D
C
Repair information
7510-XXX
4-5