Sensor (Compiler Media In) Removal - Lexmark X940e Service Manual

13. Remove the sensor(s).
Note: The sensors are identical.

Sensor (compiler media in) removal

1. Remove the finisher front door assembly. See
2. Remove the rear upper cover. See
3. Remove the rear lower cover. See
4. Remove the upper media bin assembly. See
5. Remove the upper media bin vertical cover. See
6. Remove the stapler unit frame. See
7. Remove the media eject clamp motor assembly.
page 4-65.
8. Remove the media eject unit assembly. See
9. Remove the media eject motor assembly. See
10. Remove the media compiler unit assembly. See
11. Disconnect the connector from the sensor (compiler media in) (A).
12. Release the hooks securing the sensor (compiler media in) (A) to the compiler unit assembly (B).
B
Connector
"Rear upper cover removal" on page
"Rear lower cover removal" on page
"Stapler unit frame removal" on page
C
A
"Finisher front door assembly removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
See"Media eject clamp motor assembly removal" on
"Media eject unit assembly removal" on page
"Media eject motor assembly removal" on page
"Media compiler unit assembly removal" on page
C
A
4-23.
4-22.
4-19.
4-20.
4-53.
4-58.
Repair information
7510-XXX
4-26.
4-77.
4-68.
4-71