Sensor (Finisher Media Entrance) Static Jam - Lexmark X940e Service Manual

7510-XXX
Step Check
9 Perform a print test.
Does the error remain?

282.01 Sensor (finisher media entrance) static jam

Step Check
1 Check the sensor (finisher media entrance) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 1.
5. Touch Finisher media entrance.
Does the display on the operator panel change every
time the sensing area of the above sensor is
interrupted or blocked?
2 Check the sensor (finisher media entrance) for proper
connection.
Is the above component properly connected?
3 Check the drive motor (entrance/paddle) for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Motor Tests.
4. Touch Motor (entrance/paddle).
Does the above component operate properly?
2-22
MFP Finisher Service Manual
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes No
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-115.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
sensor (finisher connector.
media entrance).
Go to "Sensor
(finisher media
entrance)
removal" on
page 4-96.
Go to step 5. Go to step 4.