Sensor (Media Eject Clamp Hp) Late Error - Lexmark X940e Service Manual

Step Check
5 Check the punch carriage shift motor for proper
connection.
Is the above component properly connected?
6
Perform a POR.
Does the error continue when the power is turned off/
on?

986.00 Sensor (media eject clamp HP) late error

Step Check
1 Check the sensor (media eject clamp HP) for proper
operation.
1. Enter the Diagnostic Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Media Path 2.
5. Touch Media eject clamp HP.
Does the display on the operator panel change every
time the sensing area of the above sensor is
interrupted or blocked?
2 Check the sensor (media eject clamp HP) for proper
connection.
Is the above component properly connected?
Yes No
Replace the Replace the
punch carriage connection.
shift motor
assembly.
Go to "Punch
carriage shift
motor assembly
removal" on
page 4-42.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-115.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
sensor (media connection.
eject clamp HP).
Go to "Sensor
(media eject
clamp HP)
removal" on
page 4-66.
Diagnostic information
7510-XXX
2-67