Sensor (Booklet Unit Media Entrance) Lag Jam - Lexmark X940e Service Manual

7510-XXX
Step
8 Check the motor (entrance/paddle) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Finisher Motor Tests.
4. Touch Motor (entrance/paddle).
Does the above component operate properly?
9 Check the motor (entrance/paddle) for proper connection.
Is the above component properly connected.
10 Perform a print test.
Does the error remain?
11 Perform a print test.
Does the error remain?

289.01 sensor (booklet unit media entrance) lag jam

Step
1 Check the booklet unit interface connector assembly.
Is the above component free of damage?
2 Check the main connector on the booklet unit sensor
interface cable assembly.
Is the above component free of damage?
2-44
MFP Finisher Service Manual
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Check
Yes
Go to step 10. Go to step 9.
Replace the drive Replace the
motor (entrance/ connection.
paddle).
Go to "Drive
motor (entrance/
paddle) and belt
(entrance/paddle)
removal" on
page 4-98.
Replace the Problem solved.
booklet controller
card assembly.
Go to "Booklet
controller card
assembly
removal" on
page 4-119.
Go to step 11.
Replace the Problem solved.
finisher controller
card assembly.
Go to "Finisher
controller card
assembly
removal" on
page 4-115.
Yes
Go to step 2. Replace the
booklet unit
interface
connector
assembly.
Go to step 3. Replace the
booklet unit sensor
interface cable
assembly.
No
No