Booklet Diverter Gate Solenoid Removal; Booklet Stapler Unit Assembly Removal - Lexmark X940e Service Manual

7510-XXX

Booklet diverter gate solenoid removal

1. Remove the rear upper cover. See
2. Remove the two screws securing the booklet diverter gate solenoid (A) to the machine.
3. Remove the booklet diverter gate solenoid (A).
4. Release the harness from the clamp.
5. Disconnect the connector from the booklet diverter gate solenoid (A).

Booklet stapler unit assembly removal

1. Open the finisher front door assembly.
2. Pull the booklet stapler unit out of the machine.
3. Release the hook securing the right ball bearing slide (A).
4. Pull the booklet stapler unit assembly (B) from the machine.
5. Remove the two screws securing the booklet stapler unit assembly (B) to the left ball bearing slide (C).
4-122
MFP Finisher Service Manual
"Rear upper cover removal" on page 4-23.