Lexmark X940e Service Manual page 157

Step Check
3 Check the bridge unit top cover assembly on the bridge
unit assembly for shape and operation.
Is the actuator of the bridge unit top cover assembly
that enters the sensor (bridge unit top cover interlock)
bent or damaged?
4 Check the bridge unit assembly top cover actuator.
Paint both faces of the actuator with a black permanent
marker.
Does the error continue?
5 Check the sensor (bridge unit top cover interlock)
installation.
Is the sensor (bridge unit top cover interlock) installed
properly?
6 Check the sensor (bridge unit top cover interlock) for
proper operation.
1. Enter the Diagnostics Menu.
2. Touch FINISHER TESTS.
3. Touch Sensor Test.
4. Touch Cover and Door.
5. Touch Cover F bridge unit top.
Does the operator panel display change every time the
detection point of the sensor (bridge unit top cover
interlock) is blocked?
7 Is the sensor (bridge unit top cover interlock)
connected properly?
8 Does the error still occur when the power is turned on?
9 Replace the finisher controller card assembly.
Go to "Finisher controller card assembly removal"
on page 4-115.
Does the error still occur when the power is turned on?
Yes No
Reshape the Go to step 3.
actuator so it fits
into the cover
sensor. If this
does not correct
the problem,
replace the
bridge unit top
cover assembly.
Go to "Bridge
unit top cover
removal" on
page 4-6.
Go to step 5 Problem solved.
Go to step 6. Reinstall the
sensor (bridge
unit top cover
interlock).
Go to
(bridge unit top
cover interlock)
removal" on
page
Go to step 8. Go to step 7.
Replace the Replace the
sensor (bridge connection.
unit top cover
interlock).
Go to "Sensor
(bridge unit top
cover interlock)
removal" on
page 4-7.
Go to step 9. Problem solved.
Replace the Problem solved.
printer engine
card assembly.
Refer to the
Printer Service
Manual.
Diagnostic information
7510-XXX
"Sensor
4-7.
2-99