7510-XXX
Sensor (stacker bin level encoder) removal
1. Remove the rear upper cover. See
2. Disconnect the connector from the sensor (stacker bin level encoder) (A).
3. Release the harness from the clamp.
4. Remove the screw securing the bracket (B) from the stacker bin lift motor assembly (C).
5. Release the hooks securing the sensor to the bracket (B).
6. Remove the sensor (stacker bin level encoder) (A).
4-34
MFP Finisher Service Manual
"Rear upper cover removal" on page
B
Clamp
C
4-23.
A
Connector
Clamp
Rear