Media Sizes That Allow Stapling; Stapling One Sheet - Lexmark X940e Service Manual

• Rear Staple (Straight) [rear straight]
This type of stapling is applied for media with a width of less than 216 mm.
The Stapler staples a set of media in parallel with the media edge after the front
tamper aligns the media to the rear side.
• Dual Staple [dual]
The Stapler staples a set of media at fixed positions (front/rear sides) in parallel
with the media edge after the front tamper aligns the media to the specified position
for each media size.

Media sizes that allow stapling

Media size that allows stapling depends on stapling positions.
The following table shows media sizes and the applicability of stapling for each staple position.
A3 SEF
A4 LEF
11 x 17 in. SEF
8.5 x 11 in. LEF
8K SEF(GCO), 16K LEF(GCO)
B4 SEF, B5 LEF
8 x 10 in. LEF
8.5 x 14 in. SEF / 8.5 x 13 in. SEF /
8.5 x 11 in. SEF
A4 SEF
8 x 10 in. SEF
Yes: Applicable, No: Not applicable

Stapling one sheet

Upon receiving the stapling command from the printer with one sheet remaining on the compiler unit assembly,
the finisher ejects the media to the stacker media bin without stapling it.
Front Rear Rear
corner corner straight
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes No
Yes No
Yes No
7510-XXX
Rear
Process direction
Front
Rear
Process direction
Front
Dual
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
No Yes
Yes Yes
Yes Yes
Yes Yes
1-23
General information