Drive Motor (Exit) Assembly And Belt (Exit) Removal - Lexmark X940e Service Manual

7510-XXX

Drive motor (exit) assembly and belt (exit) removal

1. Remove the rear upper cover. See
2. Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down as shown.
3. Remove the belt (exit) (B) from the drive motor (exit) assembly (C).
4. Disconnect the connector from the drive motor (exit) assembly.
4-110
MFP Finisher Service Manual
"Rear upper cover removal" on page
A
A
Second
First
B
C
Rear
4-23.
Connector