Assembling And Installing The Front Brake Master Cylinder - Yamaha FJR1300R Service Manual

FRONT AND REAR BRAKES
5. Check:
• brake hoses
Cracks/damage/wear → Replace.
EAS00606
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER
WARNING
@
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake
components.
1. Install:
• brake master cylinder 1
NOTE:
@
• Install the brake master cylinder holder with
the "UP" mark facing up.
• Align the end of the brake master cylinder
holder with the punch mark a in the right
handlebar.
• First, tighten the upper bolt, then the lower
bolt.
2. Install:
• copper washers 1
• brake hose 2
• union bolt 3
WARNING
@
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
"CABLE ROUTING".
4 - 28
CHAS
Recommended brake fluid
DOT 4
10 Nm (1.0 m · kg, 7.2 ft · lb)
New
30 Nm (3.0 m · kg, 22 ft · lb)