Installing The Transmission - Yamaha FJR1300R Service Manual

TRANSMISSION

INSTALLING THE TRANSMISSION

1. Install:
• main axle assembly
• shift fork "C"
• shift drum assembly
• shift fork "R"
• shift fork "L"
• shift fork guide bars
• shift drum retainer
• drive axle assembly
NOTE:
@
• When installing the main axle assembly, use
a pin to align the bearing housing bolt hole
with the corresponding hole in the upper
crankcase.
• The embossed marks on the shift forks
should face towards the right side of the
engine and be in the following sequence:
"R", "C", "L".
• Make sure the drive axle bearing circlip 1 is
inserted into the grooves a in the upper
crankcase.
• The drive axle bearing pin 2 must face
towards the rear of the crankcase.
2. Check:
• transmission
Rough movement → Repair.
NOTE:
@
Oil each gear, shaft, and bearing thoroughly.
5 - 117
ENG
12 Nm (1.2 m · kg, 8.7 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)