Yamaha FJR1300R Service Manual page 386

MIDDLE GEAR
7. Select:
• shim(s) 1
M MMM M MMM M M MMM M
a. Shims can only be selected in 0.05 mm
(0.002 in) increments, therefore round off to
the hundredth's digit of the calculated thick-
ness and select the appropriate shim with
the following chart.
b. For example, the clearance between the
crankcase and the middle driven shaft bear-
ing housing is 0.42 mm (0.017 in). There-
fore, the chart instructs you to round off the
2 to 0. Thus, you should use one 0.40 mm
(0.016 in) shim.
Hundredth
0, 1, 2
3, 4, 5, 6, 7
8, 9
Shims are supplied in the following thick-
nesses.
Middle driven pinion gear shim
Thickness (mm)
L LLL L LLL L L LLL L
8. Loosen:
• middle driven shaft bearing housing bolts
9. Install:
• shim(s)
10.Tighten:
• middle driven shaft bearing housing bolts
11.Measure:
• middle gear backlash
Out of specification → Refer to "MEASUR-
ING THE MIDDLE GEAR BACKLASH".
5 - 77
ENG
M MMM M M MMM M M MMM M MMM
Rounded value
0
5
10
0.10 0.15 0.30
0.40 0.50 0.60
L LLL L L LLL L L LLL L LLL
25 Nm (2.5 m · kg, 18 ft · lb)