Yamaha FJR1300R Service Manual page 509

EAS00752
11.Sidestand switch
• Check the sidestand switch for continuity.
Refer to "CHECKING THE SWITCHES".
• Is the sidestand switch OK?
YES
EAS00753
12.Starting circuit cut-off relay
• Disconnect the starting circuit cut-off relay
from the wire harness.
• Connect the pocket tester (Ω × 1) to the
starting circuit cut-off relay terminals as
shown.
• Check the starting circuit cut-off relay for
continuity.
Tester positive probe →
blue/green 1
Tester negative probe →
blue/yellow 2
Tester positive probe →
blue/yellow 1
Tester negative probe →
blue/green 2
1
Lg R/B L/W
L/G L/Y Sb B/Y L/W
NO
Replace the side-
stand switch.
Continu-
ity
No conti-
nuity
2
8 - 13
IGNITION SYSTEM
NOTE:
@
When you switch the positive and negative
tester probes, the readings in the above chart
will be reversed.
@
• Are the tester readings correct?
YES
EAS00754
13.Wiring
• Check the entire ignition system's wiring.
Refer to "CIRCUIT DIAGRAM".
• Is the ignition system's wiring properly con-
nected and without defects?
YES
Replace the ECU.
– +
ELEC
NO
Replace the starting
circuit cut-off relay.
NO
Properly connect or
repair the ignition
system's wiring.