STEERING HEAD
b. Remove the bearing race from the lower
bracket with a floor chisel 2 and hammer.
c. Install a new rubber seal and new bearing
races.
CAUTION:
@
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
@
• Always replace the bearings and bearing
races as a set.
• Whenever the steering head is disassem-
bled, replace the rubber seal.
L
LLL
L LLL
L
L LLL
L
4. Check:
• upper bracket
• lower bracket
(along with the steering stem)
Bends/cracks/damage → Replace.
EAS00683
INSTALLING THE STEERING HEAD
1. Lubricate:
• upper bearing
• lower bearing
• bearing races
Recommended lubricant
Lithium soap base grease
2. Install:
• lower ring nut 1
• rubber washer 2
• upper ring nut 3
• lock washer 4
Refer to "CHECKING AND ADJUSTING
THE STEERING HEAD" in chapter 3.
4 - 81
CHAS
L LLL
L
L LLL
L
L LLL
L
LLL