Removing The Swingarm; Checking The Swingarm - Yamaha FJR1300R Service Manual

SWINGARM
EAS00702

REMOVING THE SWINGARM

1. Stand the motorcycle on a level surface.
WARNING
@
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
@
Place the motorcycle on a suitable stand so
that the rear wheel is elevated.
2. Measure:
• swingarm side play
• swingarm vertical movement
M MMM M MMM M M MMM M
a. Measure the tightening torque of the swin-
garm pivot shaft, pivot shaft nut and locknut.
Pivot shaft nut
125 Nm (12.5 m · kg, 90 ft · lb)
Locknut
115 Nm (11.5 m · kg, 85 ft · lb)
Pivot shaft
7 Nm (0.7 m · kg, 5.1 ft · lb)
b. Measure the swingarm side play È by mov-
ing the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the spacers, bushing and bear-
ings.
Swingarm side play (at the end of
the swingarm)
0 mm (0 in)
d. Check the swingarm vertical movement É
by moving the swingarm up and down.
If swingarm vertical movement is not
smooth or if there is binding, check the
spacers, bushing and bearings.
L LLL L LLL L L LLL L
EAS00707

CHECKING THE SWINGARM

1. Check:
• swingarm
Bends/cracks/damage → Replace.
4 - 90
CHAS
M MMM M M MMM M M MMM M MMM
L LLL L L LLL L L LLL L LLL