Yamaha FJR1300R Service Manual page 450

WATER PUMP
4. Measure:
• impeller shaft tilt
Out of specification → Repeat steps (3) and
(4).
CAUTION:
@
Make sure the rubber damper and rubber
damper holder are flush with the impeller.
Max. impeller shaft tilt
0.15 mm (0.006 in)
1 Straightedge
2 Impeller
5. Install:
• impeller 1
• circlip
New
NOTE:
@
After installation, check that the impeller shaft
rotates smoothly.
6. Install:
• O-ring
New
NOTE:
@
Lubricate the O-ring with a thin coat of lithium
soap base grease.
7. Install:
• water pump housing
• water pump housing cover
WARNING
Always use a new copper washer.
6 - 17
COOL
10 Nm (1.0 m · kg, 7.2 ft · lb)