Yamaha FJR1300R Service Manual page 139

SYNCHRONIZING THE THROTTLE BODIES
7. Measure:
• engine idling speed
Out of specification → Adjust.
Refer to "ADJUSTING
IDLING SPEED".
Engine idling speed
1,000 ~ 1,100 r/min
8. Adjust:
• throttle body synchronization
M MMM M MMM M M MMM M
a. With throttle body #3 as standard, adjust
throttle bodies #1, #2, and #4 using the air
screw 1.
NOTE:
@
• After each step, rev the engine two or three
times, each time for less than a second, and
check the synchronization again.
• If the air screw is removed, turn the screw 3/4
turn in and be sure to synchronize the throttle
body.
CAUTION:
Do not use the throttle valve adjusting screws
to adjust the throttle body synchronization.
Carburetor angle driver
90890-03158
Vacuum pressure at engine idling
speed
33.3 kPa
(250 mm Hg, 9.8 in Hg)
NOTE:
@
The difference in vacuum pressure between
two throttle bodies should not exceed 1.33 kPa
(10 mm Hg, 0.39 in Hg).
L LLL L LLL L L LLL L
9. Measure:
• engine idling speed
Out of specification → Adjust.
Make sure that the vacuum pressure is
within specification.
10.Stop the engine and remove the measuring
equipment.
3 - 23
CHK
ADJ
THE ENGINE
M MMM M M MMM M M MMM M MMM
L LLL L L LLL L L LLL L LLL