Yamaha FJR1300R Service Manual page 399

CRANKCASE
c. Tighten the crankcase bolts further to reach
the specified angle 120° in the proper tight-
ening sequence as shown.
Crankcase bolt 1 ~ 0
Final
Specified angle 120°
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
NOTE:
When using a hexagonal bolt, note that the
angle from one corner to another is 60°.
L LLL L LLL L L LLL L
8. Tighten:
• crankcase bolts A ~ U
NOTE:
@
Tighten the bolts in the tightening sequence
cast on the crankcase.
Bolt A, B
24 Nm (2.4 m · kg, 17 ft · lb)
Bolt C, D
12 Nm (1.2 m · kg, 8.7 ft · lb)
Bolt E ~ U
10 Nm (1.0 m · kg, 7.2 ft · lb)
5 - 90
ENG
L LLL L L LLL L L LLL L LLL