Yamaha FJR1300R Service Manual page 263

FRONT FORK
3. Tighten:
• damper rod assembly bolt 1
NOTE:
@
• If the washer has not been removed during
disassembly, strike the washer lightly, and
then remove it.
• While holding the damper rod assembly with
the damper rod holder 2, tighten the damper
rod assembly bolt.
Damper rod holder
YM-01447
4. Install:
• outer tube bushing 1
(with the fork seal installer 2)
Fork seal installer
YM-01442
5. Install:
• seal spacer
• oil seal 1
New
(with the fork seal driver)
CAUTION:
@
Make sure the numbered side of the oil seal
faces up.
NOTE:
@
• Before installing the oil seal, lubricate its lips
with lithium soap base grease.
• Lubricate the outer surface of the inner tube
with fork oil.
• Before installing the oil seal, cover the top of
the front fork leg with a plastic bag 2 to pro-
tect the oil seal during installation.
4 - 67
CHAS
35 Nm (3.5 m · kg, 25 ft · lb)
New