Assembling And Installing The Front Brake Master Cylinder- Warning - Yamaha XN125 2000 Service Manual

30°
FRONT BRAKE
EAS00596
ASSEMBLING AND INSTALLING THE
FRONT BRAKE MASTER CYLINDER-
WARNING
Before installation, all internal brake
components should be cleaned and lubricated
with clean or new brake fluid.
WARNING
Never use solvents on internal brake
components.
Recommended brake fluid
DOT#3 or DOT#4
1. Install:
• copper washers
• brake hose
• union bolt
WARNING
Proper brake hose routing is essential to
insure safe scooter operation. Refer to "CA-
BLE ROUTING".
NOTE:
• While holding the brake hose, tighten the union
bolt as shown.
• Turn the handlebar to the left and to the right to
make sure the brake hose does not touch other
parts (e.g., wire harness, cables, leads). Correct
if necessary.
3. Fill:
• brake master cylinder reservoir
(with the specified amount of the
recommended brake fluid)
Recommended brake fluid
DOT#3 or DOT#4
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
7-18
CHAS
26 Nm (2.6m•kg)