Installing The Clutch - Yamaha FJR1300R Service Manual

CLUTCH
EAS00294

INSTALLING THE CLUTCH

1. Install:
• clutch housing 1
NOTE:
@
• Make sure that the slots a into the clutch
housing align with the tabs b onto the oil
pump drive sprocket.
• Make sure that the primary driven gear teeth
and primary drive gear teeth mesh correctly.
• Insert a cross-headed screwdriver into one of
the holes of the clutch housing and primary
driven gear, and then rotate the inner pri-
mary driven gear until both primary driver
gears are aligned. The teeth of both primary
driven gears must be aligned for installation.
2. Install:
• spacer
NOTE:
@
Install the spacer with the two screw holes fac-
ing towards the clutch boss.
3. Install:
• clutch boss assembly 1
NOTE:
@
• If the wire circlip 2 has been removed, care-
fully install a new one as shown.
• Install the clutch spring plate 3 with the
"OUTSIDE" mark facing out.
5 - 51
ENG