Troubleshooting - Yamaha FJR1300R Service Manual

EAS00737

TROUBLESHOOTING

The ignition system fails to operate (no
spark or intermittent spark).
Procedure
Check:
1. main and ignition fuses
2. battery
3. spark plugs
4. ignition spark gap
5. spark plug cap resistance
6. ignition coil resistance
7. crankshaft position sensor resistance
8. main switch
9. engine stop switch
10.neutral switch
11.sidestand switch
12.starting circuit cut-off relay
13.wiring connections
(of the entire ignition system)
NOTE:
@
• Before troubleshooting, remove the following
part(s):
1) Seat
2) Fuel tank and T-bar
3) Side cowlings
4) Front cowling assembly
5) Air filter case
• Troubleshoot with the following special
tool(s).
Dynamic spark tester
YM-34487
Pocket tester
YU-03112
EAS00738
1. Main and ignition fuses
• Check the main and ignition fuses for conti-
nuity.
Refer to "CHECKING THE FUSES" in
chapter 3.
• Are the main and ignition fuses OK?
YES NO
Replace the fuse(s).
8 - 10
IGNITION SYSTEM
EAS00739
2. Battery
• Check the condition of the battery.
Refer to "CHECKING AND CHARGING
THE BATTERY" in chapter 3.
Minimum open-circuit voltage
12.8 V or more at 20 °C (68 °F)
• Is the battery OK?
YES
EAS00741
3. Spark plugs
The following procedure applies to all of the
spark plugs.
• Check the condition of the spark plug.
• Check the spark plug type.
• Measure the spark plug gap.
Refer to "CHECKING THE SPARK PLUGS"
in chapter 3.
Standard spark plug
CR8E (NGK)
U24ESR-N (DENSO)
Spark plug gap
0.7 ~ 0.8 mm (0.028 ~ 0.031 in)
• Is the spark plug in good condition, is it of
the correct type, and is its gap within speci-
fication?
YES
– +
ELEC
NO
• Clean the battery
terminals.
• Recharge or
replace the battery.
NO
Re-gap or replace
the spark plug.