Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha FJR1300R Service Manual

GEN
IMPORTANT INFORMATION
INFO
EAS00023
LOCK WASHERS/PLATES AND COTTER
PINS
After removal, replace all lock washers/plates
1 and cotter pins. After the bolt or nut has
been tightened to specification, bend the lock
tabs along a flat of the bolt or nut.
EAS00024

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the manu-
facturer's marks or numbers are visible. When
installing oil seals, lubricate the oil seal lips
with a light coat of lithium soap base grease.
Oil bearings liberally when installing, if appro-
priate.
1 Oil seal
CAUTION:
@
Do not spin the bearing with compressed
air because this will damage the bearing
surfaces.
1 Bearing
EAS00025

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip 1, make sure the
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
4 Shaft
1 - 36