Yamaha FJR1300R Service Manual page 476

Code No. 33
Used diagnostic code No. 30 (ignition coil #1, 4)
Inspection operation item and probable cause Operation item and countermeasure
Defective ignition coil (test the primary and
secondary coils for continuity).
Open or short circuit in lead wire.
Connected state of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
Code No. 34
Used diagnostic code No. 31 (ignition coil #2, 3)
Inspection operation item and probable cause Operation item and countermeasure
Defective ignition coil (test the primary and
secondary coils for continuity).
Open or short circuit in lead wire.
Connected state of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
Code No. 41
Used diagnostic code No. 08 (lean angle cut-off switch)
Inspection operation item and probable cause Operation item and countermeasure
Defective lean angle cut-off switch
Open or short circuit in lead wire.
Connected state of connector
Inspect the coupler for any pins that may
have pulled out.
Check the locking condition of the coupler.
FUEL INJECTION SYSTEM
Symptom Malfunction detected in the primary wire of the ignition coil (#1, 4).
Replace if defective.
Refer to "IGNITION SYSTEM" in chapter 8.
Repair or replace if there is an open or short
circuit.
Main wiring harness
Orange - Orange
Red/Black - Red/Black
If there is a malfunction, repair it and connect it
securely.
Ignition coil primary side coupler - Orange
Main wiring harness ECU coupler
Symptom Malfunction detected in the primary wire of the ignition coil (#2, 3).
Replace if defective.
Refer to "IGNITION SYSTEM" in chapter 8.
Repair or replace if there is an open or short
circuit.
Main wiring harness
Gray/Red - Gray/Red
Red/Black - Red/Black
If there is a malfunction, repair it and connect it
securely.
Ignition coil primary side coupler - Gray/Red
Main wiring harness ECU coupler
Symptom Open or short circuit detected in the lean angle cut-off switch.
Replace if defective.
Repair or replace if there is an open or short
circuit.
Main wiring harness
Black/Blue - Black/Blue
Yellow/Green - Yellow/Green
Red/White - Red/White
If there is a malfunction, repair it and connect it
securely.
Lean angle cut-off switch coupler
Main wiring harness ECU coupler
7 - 25
FI
Reinstatement
method
Reinstated by
starting the engine
and operating it at
idle.
Reinstatement
method
Reinstated by
starting the engine
and operating it at
idle.
Reinstatement
method
Reinstated by turn-
ing the main switch
ON.