Yamaha FJR1300R Service Manual page 136

ADJUSTING THE VALVE CLEARANCE
3 - 20
e. Install the new valve pad 1 and the valve
lifter 2.
NOTE:
@
• Lubricate the valve pad with molybdenum
disulfide grease.
• Lubricate the valve lifter with molybdenum
disulfide oil.
• The valve lifter must turn smoothly when
rotated by hand.
• Install the valve lifter and the valve pad in the
correct place.
f. Install the exhaust and intake camshafts,
timing chain and camshaft caps.
Camshaft cap bolt
10 Nm (1.0 m · kg, 7.2 ft · lb)
NOTE:
@
• Refer to "INSTALLING THE CAMSHAFTS —
CAMSHAFTS" in chapter 5.
• Lubricate the camshafts, camshaft lobes and
camshaft journals.
• First, install the exhaust camshaft.
• Align the camshaft marks with the camshaft
cap marks.
• Turn the crankshaft clockwise several full
turns to seat the parts.
g. Measure the valve clearance again.
h. If the valve clearance is still out of specifica-
tion, repeat all of the valve clearance adjust-
ment steps until the specified clearance is
obtained.
L LLL L LLL L L LLL L L LLL L
CHK
ADJ
L LLL L L LLL L LLL