Ricoh M065 Service Manual page 423

[Fusing Temperature Display] Fusing Temperature Display (Heating or
Pressure)
1106
Displays the current temperature of the heating and pressure rollers.
001 Fusing Roller: Center
002 Fusing Roller: Ends
The heating roller has two lamps. One heats the center of the heating roller
and the other heats both ends of the heating roller.
003 Pressure Roller: Center
The pressure roller has two lamps. One heats the center of the heating roller
and the other heats both ends of the heating roller.
[Ready Temp Setting]
1108
Japan use only
007 Ready Temp Time
1109 [Fusing Nip Band Check]
001 Execute
Pre-Idling Time
002
Specifies the fusing rotation time before executing SP1109-001.
Stop Time
003
Specifies the time for measuring the nip.
SM Appendix
- [–20 to 250 / 0 / 1 deg/step]
- [–10 to 250 / 0 / 1 deg/step]
- [–10 to 250 / 0 / 1 deg/step]
*ENG
[22 to 60 / 43 / 0.1 sec/step]
[0 or 1 / 0 / 1]
Executes the nip band measurement
between fusing belt and pressure roller.
-
If the nip band width is not 8 mm, and
fusing is not good, replace the pressure
roller or install a new fusing unit.
*ENG [0 to 120 / 0 / 1 sec/step]
* ENG [5 to 30 / 20 / 1 sec/step]
8-13
System Service Mode
M065/M066