Ricoh M065 Service Manual page 243

7. Turn off the main switch. Then unplug the power cord.
8. Replace the NVRAM on the controller. Then reassemble the machine.
9. Check if the serial number appears on the operation panel. (
the serial number if it does not appear. (Contact your supervisor about this setting.)
10. Plug in the power cord. Then turn the main switch on.
11. Copy the data from the SD card to the NVRAM (
(SP5-846-52) if you have successfully copied them to the SD card.
The counter data in the user code information clears even if step 11 is done
correctly.
An error message appears if the download is incomplete. However, you can
still use the part of the address book data that has already been downloaded
in step 11.
An error message appears when the download data does not exist in the SD
card, or, if it is already deleted.
You cannot do this procedure if the SD card is write-protected.
12. Go out of SP mode. Then turn the main switch off. Then remove the SD card from SD
card slot 2.
13. Turn the main switch on.
SM
SP5-825-001) and HDD
4-151
Electrical Components
SP5-811-002). Input
M065/M066