Ricoh M065 Service Manual page 376

Process Control Results
No. Result
9 Vcnt error 3
The machine starts developer initialization after you set "Enable" in SP3-902-005,
006, 007, or 008. Developer initialization automatically resumes when you open
and close the front door or turn the main switch off and on if an error other than
Error 8 occurs.
M065/M066
Description
±0.2V.
Vcnt is less than 4.7V.
4-2
Possible Causes/Action
1. Make sure that the heat seal on the
development unit is not removed
2. Defective TD sensor
3. Vt target settings are not correct.
4. Toner density error
SM Appendix