Ricoh M065 Service Manual page 415

007 Paper Feed Temp:P-Roller
008 P.Feed Temp:MThick:P-Roll:BW
009 P.Feed Temp:MThick:P-Roll:FC
010 Upper Limit Temp
011 Offset: Feed Start
012 Offset: Feed Start: M-Thick
Offset: Feed Start: 600dpi: Plain1:
013
BW
Offset: Feed Start: 600dpi: Plain2:
014
BW
030 Offset: Feed Start: Time
031 Offset:Feed Start:1200dpi
033 Offset: Feed Start: Glossy
1105 [Fusing Temperature] Fusing Temperature Adjustment
(Printing Mode, Roller Type, [Color], Simplex/Duplex)
Roller Type –> Center and Ends: Heating roller, P-Roller –> Pressure roller
Paper Type -> Plain, Thin, Thick, OHP, Middle Thick, Special
Fusing Ready Temp
001
Specifies the heating roller target temperature for the ready condition.
002 Fusing Ready: Offset
003 P-Roll Ready Target Temp.
P-Roll Ready Temp
Sets the heating roller offset temperature at the end of the heating roller. This
007
value is one of the thresholds to determine if the machine is at the heating
roller target temperature during warm-up.
010 Stand-By: Center
SM Appendix
*ENG [0 to 160 / 90/ 1 deg/step]
*ENG [0 to 160 / 100/ 1 deg/step]
*ENG [0 to 160 / 100/ 1 deg/step]
*ENG [0 to 100 / 25/ 1 deg/step]
*ENG [0 to 100 / 20/ 1 deg/step]
*ENG
[0 to 100 / 10/ 1 deg/step]
*ENG [0 to 100 / 25/ 1 deg/step]
*ENG
[0 to 100 / 25/ 1 deg/step]
*ENG [15 to 500 / 60 / 1 sec/step]
*ENG [0 to 100 / 15 / 1 deg/step]
*ENG
[0 to 100 / 15/ 1 deg/step]
*ENG [100 to 180 / 160 / 1 deg/step]
*ENG [5 to 30 / 11 / 1 deg/step]
*ENG [50 to 160 / 120 / 1 deg/step]
*ENG
[0 to 150 / 20 / 1 deg/step]
* ENG [50 to 180 / 160 / 1 deg/step]
8-5
System Service Mode
M065/M066