Ricoh M065 Service Manual page 446

System Service Mode
[Erase Margin Adjust] (Area, Paper Size)
2103
Adjusts the erase margin by deleting image data at the margins.
001 Lead Edge Width
002 Trailing Edge Width
003 Left
004 Right
[LD Initial Power Adjust]
2104
Adjusts the LD initial power. These SPs must be input only when a new laser
unit is installed.
001 LD1: K
002 LD2: K
003 LD1: C
004 LD2: C
005 LD1: M
006 LD2: M
007 LD1: Y
008 LD2: Y
[LD Power Adjust] DFU
(Process Speed, Color)
2105
Adjusts the LD power of each color for each process speed.
Each LD power setting is decided by process control.
Low: 85 mm/s, High: 260 mm/s, Middle: 182 mm/s
001 Bk: Standard Speed
002 C: Standard Speed
003 M: Standard Speed
M065/M066
*ENG
[0 to 9.9 / 4.2 / 0.1 mm/step]
*ENG
*ENG
[0 to 9.9 / 2 / 0.1 mm/step]
*ENG
*ENG
*ENG
*ENG
*ENG
[60 to 140 / 100 / 0.1 %/step]
*ENG
*ENG
*ENG
*ENG
*ENG
[50 to 120 / 100 / 1%/step]
Decreasing a value makes lines
*ENG
thinner on the output.
Increasing a value makes lines
*ENG
8-36 SM Appendix