Rev. 08/10/2011
⇒
5. Push the green PCDU lever with your finger, as far as it will go (at least until you hear
a click).
6. Check the pentagon-shaped window for all four colors. If you can see a red area, as
shown in the "Incorrect" photo below, this means the unit was not installed correctly.
⇒
7. Make sure that the white locking tab on
the PDCU (circled in red below) is inside
the hole of the bracket. Do this for all four
PDCU's.
NOTE: If the white locking tab is not locked
into the slot on the bracket, reseat the
PDCU until it properly locks into place.
SM
Correct
Correct
O K
Incorrect
Incorrect
N G
Correct
OK
Incorrect
4-21
Image Creation
NG
M065/M066