Mmc: 837 Sip Options - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
MMC: 837
DESCRIPTION:
This MMC permits the adjustments of optional Session Initiation Protocol (SIP)
trunking parameters. The MGI supports SIP and H.323 on a per call-per-port basis.
The settings are systemwide.
NOTE: When changing any IP address/value, listed below, three digits must
be input for each (octet) field. Example 192.168.1.10 input must be: 192 168
001 010
• GATEWAY CALL ID: This a 1 to 12 digit numeric entry that identifies this
system.
• CALLER ID TYPE: This option controls the calling party identification type.
There are 3 possible selections: ANI which shows the calling station number
when the call is MGI to MGI, IP which shows the calling MGI IP address, and
GWID which is a 1 to 12 digit preprogrammed ID.
• DEFAULT DIL NO.: This allows programming of the default DIL number when
digits are missing, or incorrect on an inbound call.
• UDP PORT: TRUNK: Sets the UDP port used on a trunk call.
• UDP PORT: PHONE: Sets the UDP port used on a SIP phone call.
• RE-TRANS. T1 TIME: The initial re-transmission time if no answer based on the
RFC2543 specification. Default 500ms. The range is 0~9900.
• RE-TRANS. T2 TIME: The maximum re-transmission time if no answer based on
the RFC2543 specification. Default 4000ms. The range is 0~9900.
• RE-TRANS. T4 TIME: The time the User Agent Server waits after receiving the
ACK message. Based on the RFC2543 specification. Default 5000ms. The range
is 0~9900.
• GENERAL RING TM: The server shall retransmit the response during this
amount of time until the requested retransmission is received. For example, the
wait time after sending 200 OK for INFO. The range is 0~99900.
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006
SIP OPTIONS