Samsung OfficeServ 7400 Technical Manual page 359

OfficeServ 7400
TECHNICAL MANUAL
ALM ALM
NO. CODE
MJE10
MJE11
MJE12
MNF32
MNF33
61 MNF01
62 MNF02
63 MNF03
64 MNF04
65 MNF05
66 MNF06
67 MNF07
68 MNF08
69 MNF09
70 MNF10
71 MNF11
MMC: 852
ALARM
SVMi Card Restart
SVMi Card Halt
SVMi Card Down
SVMi Card Ready
SVMi Card Request
Card Out
Card In
IPC Error
Trunk Fault
Trunk Recovery
Trunk Disconnect
Trunk Connect
SIO TXQ Over
SIO TXQ Under
T1 Out of Service
T1 In Service
Home Page
PROGRAMMING
PART 2 JUNE 2006
DEFINITION
Card Restarted
Card Halted
Card When Down
[SVMi-16 Only] Alarm Code when SVMi-
16 is Ready.
Alarm Code when SVMi card request
the number to MCP after restarting.
A circuit card mounted in a universal slot
has been removed from service or is not
recognized by the Common Control
Processor
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
A circuit card mounted in a universal slot
has been returned to service.
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
Inter processor communication error
has occurred.
Alarm Data = Cabinet-Slot (C1,2)-(S 1
through 10)
Out of service trunk detected via loop
detect. Internal CODEC test.
Alarm Data = Cabinet-Slot Port (C1,2)-
(S1 through 10), (P1 through 16)
Out of service trunk detected via loop
detected as out of service is now
operational.
Alarm Data = Cabinet-Slot Port (C1,2)-
(S1 through 10), (P1 through 16)
Out of service trunk detected via seizure
of trunk. External seizure test.
Alarm Data = Cabinet, Slot Port (C1,2)-
(S1 through 10), (P1 through 16)
Out of service trunk recovered via
seizure of trunk External seizure test.
Alarm Data = Cabinet, Slot Port (C1,2)-
(S1 through 10), (P1 through 16)
SMDR buffer above 80% capacity.
SMDR buffer below 80% capacity.
A T1 digital line is out of service
T1 Digital line has been restored to
normal service.
Alarm Data = Cabinet,Slot (C1-
2,S1 through 10)
Table of Contents