Samsung OfficeServ 7400 Technical Manual page 323

OfficeServ 7400
TECHNICAL MANUAL
PHONE TYPE: This the type of IP keyphone used. SAMSUNG or SIP (future).
•
Please use SAMSUNG for the ITP series of keyphones.
REGIST CLR: This is used to clear the registration of a particular IP keyphone.
•
If a keyphone is relocated to a different physical subnet, it is very important that
the keyphone registration is cleared and re-established with the proper IP
information.
FRAME CNT*: This is the sampling rate per frame. The lower the frame count
•
the higer the bandwidth consumed per call. Range is 20 ms ~ 40 ms. Applies
only to ITP calls.
JITTER SIZE*: This is the programmable time delay to buffer packets. Range 10
•
ms~90 ms. Applies only to ITP to ITP calls.
TOS FIELD*: Allows the setting of Type of Service bits to allow precedence
•
when using router that support this field. Applies only to ITP to ITP calls.
SW VERSION: Software version of the particular ITP keyset. View only.
•
SW UPGRADE: This is an IP phone software upgrade command. The TFTP
•
server address must be programmed in MMC 841 for this to work. When
selecting YES and pressing the right soft key, the selected ITP will be upgraded
to software on TFTP server. MMC 841, "ITP version upgrade" must be set to
MMC command.
TIME ZONE: Sets the time off-set of IP phone from the system clock. This is
•
used for IP phones on different time zones than the system. By adjusting this
parameter the remote ITP phone's clock display will show local time of the time
zone where it is located.
PUB TO PUB: When set to "USE MGI" calls between two remote ITP phones
•
located in the same private zone (or same public zone) will be forced to use an
MGI channel. Select the "USE MGI" option if you encounter one-way audio or no
audio between remote ITP phones.
PRIVATE IP: Displays the private IP address (local IP) of the ITP phones (view
•
only).
SIG TYPE
•
Note: These settings are effective only if MMC 841, "ITP DSP PARA",
DOWN=PHONE DATA.
MMC: 840
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006