Samsung OfficeServ 7400 Technical Manual page 85

OfficeServ 7400
TECHNICAL MANUAL
05 DISA MOH :OFF
06 TRANSFER MOH :OFF
08 DID BSY ROUT :OFF
09 ALARM MOH: OFF
13 RECALL PICKUP :ON
14: ICM EXT FWD :OFF
16: DID ERR TONE :OFF
24 TRSF CANCEL :OFF
32 ISDN PROGCON:OFF
36 DSS KEY DPU :OFF
37 BEGN DGT DSP :ON
MMC: 210
When this option is turned ON outside parties will hear
trunk MOH instead of dial tone from the time the system
answers a DISA trunk until the caller dials a digit. System
default is OFF.
When this option is turned ON outside parties will hear
trunk MOH instead of ring back tone from the time a
transfer is completed until the call is answered by an
internal party. System default is OFF.
When this option is turned on a DID call directed to a busy
station will reroute to the operator if camp on is set to OFF
in MMC 714. If the option is set to ON the call will re route
to the destination in MMC 406 for that trunk.
When ON allows stations to hear MOH after answering an
alarm reminder call.
When this option is turned on a call recalling to a station
can be picked up using Direct Call Pickup, Pickup Group
and My Group features. This applies to held calls recalling
and transferred calls recalling to a station.
When this option is on call forward external is allowed
when intercom calls are placed to a station that has Call
Forward External programmed and set.
This option was added to provide error tone when an
invalid DID number is received. The OfficeServ 7400 error
tone should not be sent to the public network in the USA.
When turned OFF a single line phone will be able to
handle 2 calls simultaneously. Using the hook-flash to
toggle between them. When turned ON a single line
telephone will be able to connect to the 2
pressing the h/f will not toggle between the two calls it will
nd
disconnect the 2 call and reconnect the single line
telephone to the first call.
This option, when ON, determines if the system will wait
for an answer signal before allowing DTMF to be sent on
an ISDN circuit. (L Version Only)
When set to ON, the station can make a directed call
pickup, by pressing the flashing DSS key of the ringing
station.
When ON and an outside call is made via speed dial or
LNR where more than 11 digits are dialed, then only the
first 11 digits dialed are shown on the keyphone display.
When OFF, the last 11 digits are displayed.
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006
nd
call, but