Samsung OfficeServ 7400 Technical Manual page 333

OfficeServ 7400
TECHNICAL MANUAL
No. Parameter
1 GATEWAY
2 NET MASK
3 MAC ADDR
4 VERSION
5 STATUS
6 USE RF CH
7 TX POWER
8 TIMEZONE
8 PARA CLR
Connecting WBS24
WBS24 has two types, i.e. COMBO and BASIC. Two types of WBS24 is simultaneously
unavailable in one system.
According to the AP type, CWBS is displayed if WBS24 is set to Combo, and BWBS if
set to Basic on the LCD display. The AP type can be set in [AP TYPE] of [MMC 849].
<SIP Parameter>
Normally, use the default without change.
No. Parameter
0 RE-TRANS T1
1 RE-TRANS T2
2 RE-TRANS T4
3 GEN RING TM
MMC: 845-COMBO
Gateway address of the network in which WBS24 is installed
(Mandatory entry item)
Netmask of the network in which WBS24 is installed
(Mandatory entry item)
WBS24 MAC address received by the system if WBS24 is connected
Current software version of WBS24 connected to the system
Alive operation status of WBS24 connected to the system
RF channel number used in each WBS24
TX POWER of each WBS24. Level 1 is minimum, level 4 is maximum.
In case of WBS24(Basic), this parameter can be independently set at
the area with a different time zone. This value is settings to correct time
Initializes the WBS24 entry information
When using Unreliable transmission protocol such as UDP,
retransmission is performed if there is no response after transmission.
RE-TRANS.T1 TIME is the Initial Retransmission Interval defined in
RFC2543.
Maximum Retransmission Interval defined in RFC 2543.
Available for multiple purposes in RFC 2543. This parameter is used
as time when User Agent Server(UAS) receives the ACK message
and waits in the Unreliable transmission protocol.
In the Unreliable transmission protocol, it is not sure that the client
receives a response after the server sends the last response. At this
time, the server should retransmit a response during this time until it
receives the requested retransmission. For example, it is the time to
Home Page
PART 2 JUNE 2006
Description
Description
Table of Contents
PROGRAMMING