Defaulting The System - Samsung OfficeServ 7400 Technical Manual

OfficeServ 7400
TECHNICAL MANUAL
NAND FLASH. NAND FLASH is what is loaded into the DRAM when the system
boots back up.
Thus it is highly recommended that you frequently log out of KMMC or WebMMC
programming to force the DRAM to save to NAND FLASH.

1.4 DEFAULTING THE SYSTEM

You can no longer default the system by turning the MP40 battery backup switch OFF
then ON again. Turning the battery backup switch OF then ON again will simply clear
the SRAM which contains the data mentioned above. You can default the OS7400 in
the following ways:
1) MMC 811 MEMORY CLEAR (however mmc 830 IP address information will be
retained).
2) Leave the MP40 battery backup switch in the OFF position and boot the system.
This is a FULL default. You will have to power down and turn the battery back up
switch back ON and reboot.
3) When the Country Selection is changed by MMC 812 or the MP40 DIP SWITCHES
When first installing this system, always use MMC 811 to reset and clear memory.
This will ensure that you begin with clean default data.
Now begin entering customer data
IMPORTANT REMINDER
1.3.2
Table of Contents
Home Page
PROGRAMMING
PART 1 JUNE 2006