Samsung OfficeServ 7400 Technical Manual page 317

OfficeServ 7400
TECHNICAL MANUAL
• INVITE LING TM: After the client sends ACK for the INVITE Final Response, the
client cannot confirm if the server received the ACK message. The client waits for
this amount of time after sending ACK for the Final Response. The range is
0~99900.
• PROVISIONAL TIME: After receiving the Provision Response, the User Agent
shall wait for this amount of time until Timeout ends. The range is 0~999900.
• INV.NO RESP TIME: Before sending Cancel for the Invite Request, the User
Agent shall wait for this amount of time. The range is 0~99900.
• GEN.NO RESP TIME: Before sending Cancel for General Request, the User
Agent shall wait for this amount of time. The range is 0~99900.
• REQ.RETRY TIME: After sending General Request, the User Agent shall wait for
the Final Response for this amount of time. The range is 0~99900.
• SIP SERVER ENBLE: ENABLE or DISABLE to use an optional external industry-
standard SIP Server.
• SIP SERVER IP: Sets SIP server IP address.
• SIP SERVER PORT: Sets the port to use on the SIP Server.
• SIGNAL PORT: Indicate the port number for signaling and sets a range of
numbers allowed by firewall equipment. The common/default IP path or port
used is 10000
• SEND CLIP TABLE: Refers to SEND CLI NUMBER (MMC 321), which provides
calling party identification when using the MGI as a trunking gateway. This
provides station ID of the calling station. A single digit value corresponding with
the desired table in MMC 321 should be entered here. This is only used when
MMC 405 value is null.
• INCOMING MODE: This option selects how incoming calls are routed:
FOLLOW DID TRANS [default] (MMC 714), FOLLOW TRUNK RING (MMC 406),
or FOLLOW INCOM DGT (MMC 724) when the MGI is used as a trunking
gateway.
• REGISTER T-GW: Trunk gateway number to register STP server.
• ALLOW GW CHECK: Enable the check for the presence of a gateway.
• SIP REGISTERED: Displays registration status to the SIP server.
MMC: 837
Table of Contents
Home Page
PROGRAMMING
PART 2 JUNE 2006