Main Input; Input Switching & Pip Menu - Christie Roadster S+14K-J User Manual

Section 3: Operation
CHANGE LAMP - Submenu
Initiates the lamp change process and allows the serial number of the new lamp to be entered.
Lamp serial numbers are used for keeping statistics on each lamp. Entering of serial numbers is optional, but is
recommended.
When using this function, the statistics from the previous lamp are archived, and statistics for the new lamp are
tracked. If this function is not used, statistics are accumulated (combined) for both the new and old lamps.
LAMP HISTORY
Lists the serial number and the number of hours logged for the lamp (current and previously) installed in the
projector. The current lamp appears at the bottom of the list. This entry is added automatically when you record
a new serial number during the lamp change process. See
3.10 Input Switching & PIP Menu
Use the Input Switching & PIP menu to
enable and define how you want to use PIP.
To control the primary image, access
NOTE:
all picture controls through the Main menu.
To control the secondary (PIP) image, access
picture controls through the Input Switching
& Picture-in-Picture menu.

MAIN INPUT

From the list of active inputs, select one to be
used as the primary or main image.
PIP INPUT
From the list of active inputs, select one to be used as the secondary or PIP.
SWAP MAIN & PIP INPUTS
Toggle the current PIP relationship so that the primary (main) image becomes secondary (PIP), and the
secondary image becomes primary. Swapping is available only when PIP is enabled.
experience a slight delay when swapping the Primary and Secondary images.
PIP ENABLE
Short cut: Press PIP on the Remote if menu not
present.
Toggle between displaying two sources at once
(Main and PIP images) and the primary or main
source only. This check box turns the secondary
source on and off.
3-52
CHANGE LAMP - Submenu.
F 3-39 I S
IGURE NPUT
J Series 2.0, 2.4, and 3.0kW User Manual
& PIP
WITCHING
You may
NOTE:
020-100707-01 Rev. 1 (10-2011)