Swapping main input and second input source
Switch the main input source with second input source. Before this action, make sure to enable
picture-in-picture/picture-by-picture.
1. Select Menu > Input Switching & PIP > Swap.
2. To swap, select ENTER.
Setting the size of second input source
Set the size of picture-in-picture (PIP)/picture-by-picture (PBP). Before this action, make sure to
enable PIP/PBP. See
Input sources layout and size
size.
1. Select Menu > Input Switching & PIP > Size.
2. Select the appropriate size, small, medium or large, for PIP/PBP input source.
3. To confirm the selection, select ENTER.
Setting up the display layout with two input
sources
Set the display location for main input source and second input source on the screen. Before this
action, make sure to enable PIP/PBP. See
details of the layout and size.
1. Select Menu > Input Switching & PIP > Layout.
2. Select the appropriate layout.
3. To confirm the selection, select ENTER.
Input sources layout and size
A P indicates the primary source region (lighter color) and an asterisk (*) indicates both regions are
the same size.
PIP/PBP layout
PBP, Main Left
PBP, Main Top
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
on page 70 for further details of the layout and
Input sources layout and size
PIP/PBP size
Small
Medium
P
P
P
P
Configuring input settings
on page 70 for further
Large
*
P
*
P
70