Alignment Brush Roller Replacement - Ricoh FT8880 Service Manual

REPLACEMENT AND ADJUSTMENT

5.4 ALIGNMENT BRUSH ROLLER REPLACEMENT

[I]
1. Remove the rear cover.
2. Mark the position of the tension bracket [A] and loosen the screw [B].
3. Remove the 2 E-rings [C], slide out the pulley [D] and bushing [E], and
remove the alignment brush roller assembly [F].
4. Remove the screws [G], E-rings [H], pins [I], and remove the brush rollers
[J].
NOTE: 1. When reassembling, put the bracket [A] back to the marked
position.
2. Do not lose the pins [I].
[C]
[B]
[A]
[F]
[H]
[J]
[G]
30
5 June 1992
[A]
[E]
[C]
[D]