Ricoh FT8880 Service Manual page 116

6 March 1992
[H]
3. Run the menu reader harness [A] through the bracket hole [B].
4. 220/230/240 V versions only
Install the ferrite core [C] on the menu reader harness as shown.
5. Canadian market machines only
To comply with C.S.A. standards, connect the sub harness [D] for C.S.A.
(P/N: A9529506) to the 10p connector of the menu reader harness.
6. Connect the 10p connector of the menu reader harness to CN110 of the
main control board and secure the grounding wire [E] with a M4 x 6 screw.
NOTE: Do not use the screw longer than 6 mm for securing the
grounding wire, otherwise the screw contacts the development
unit.
7. Clamp the menu reader harness (1 clamp [F] and 1 screw).
8. Reinstall the left top cover. (Pass the menu reader harness through the
cutout [G] of the left top cover.)
NOTE: Do not use the screw longer than 6 mm for 4 screws [H], other
wise the screw contacts the first scanner.
[B]
[G]
9
INSTALLATION PROCEDURE
[A]
[F]
[C]
[E]
[D]