Ricoh FT8880 Service Manual page 42

5 June 1992
26. Remove the copier left upper cover [A] (2 screws) and left lower cover [B]
(3 screws).
27. Cut 2 binds [C] for the LCT interface harness by the pliers.
28. Secure the ground wire [D] to the copier (1 screw).
29. 220/230/240 V version machines only
If the voltage of electrical power supply from wall outlets is 220 V or 240
V, change the voltage as follows:
a) Disconnect the input line [E] from the 230 V connector.
b) Disconnect the dummy connector [F] from the appropriate voltage (220
V or 240 V).
c) Connect the input line to the appropriate voltage (220 V or 240 V).
d) Connect the dummy connector to the 230 V connector.
[C]
[B]
[F]
[E]
INSTALLATION PROCEDURE
[D]
3-11
[A]