Ricoh FT8880 Service Manual page 137

INSTALLATION
3.2 INSTALLATION PROCEDURE
CAUTION: Unplug the copier power cord before starting the following
procedure.
[A]
[C]
1. Remove the strips of filament tape [A] on the finisher and remove the
styrofoam blocks [B]. Remove the fixing screws [C].
2. Open the finisher front door and pull out the transport unit [D]. Then,
remove the strips of filament tape [E] and cut the bind [F] for the stapler
using pliers.
3. Push the transport unit in its original position and close the front door.
[B]
[C]
[F]
18
5 June 1992
[E]
[D]