Ricoh FT8880 Service Manual page 43

INSTALLATION PROCEDURE
[F]
[B]
[F]
30. Pass 6 connectors of the interface harness [A] through the rear upper
hole [B] of the left lower cover and reinstall the left lower cover. Do not fix
the screw [C]. Set 6 connectors to the connectors of the LCT harness [D].
31. Mount the LCT unit on the copier (Insert the 2 mounting studs [E] into the
docking holes [F]).
32. Fix the LCT unit to the copier (1 screw).
33. Screw down the feet [G] to level the LCT so that the LCT is parallel to the
main copier (see illustration).
34. Guidance ROM Kit installation (-27 versions only). Remove the operation
unit rear cover [H] (4 screws) and install the appropriate ROMs [I] to the
operation unit board. Distinguish the chips (0, 1, and c) by the last 4 digits
of their part number. The lowest one is installed at 0, the middle one at 1,
the highest one at c.
35. Reinstall all the covers.
36. Install the copy tray or follow the finisher unit installation.
37. Plug in the power cord and turn on the main switch.
38. Check the copy quality and the copier operation.
[D]
[G]
[A]
c
[I]
[E]
[C]
1
0
3-12
5 June 1992
[H]