Ricoh FT8880 Service Manual page 192

SERVICE TABLES
4.4 DIP SW TABLE
DIP SW100 (MODE) SP mode
1 2
0 0
1 0
0 1
1 1
0 0
0 0
1. "Sorter Free Run", "Staple Unit Free Run" or "Sorter & Staple Unit Free
Run" starts operation when the DIP switches are set as shown in the
table.
2. "Lower Staple Unit" starts operation when TP103 is short- circuited to
TP100 (GND), after setting DIP SW100-3 to 1.
3. Bin/Jam sensor can be adjusted by VR100 and VR 101 after setting DIP
SW100-4 to 1.
Operation
1. Sorter Free Run
1) Main motor turns on.
2) Side bar moves to the A4 position.
3) By-pass tray gate moves to the upper position.
4) Pressure release solenoid is energized for 2.4 seconds.
5) Bin solenoids turn on at the 1st bin continuing in order down to the
20th bin.
6) Jogger moves at each bin.
7) Machine stops operation for one second and then repeats the above
operation from 1).
2. Staple Unit Free Run
The sorter stapler repeats the staple operation in order from the 1st bin to
the 20th bin.
3. Sorter and Staple Unit Free Run
The sorter stapler works as if 20 sets of 2 A4 papers are present and
sorted in auto staple mode.
4. Lower Staple Unit
Staple unit lowers until it reaches to the 20th bin and stops.
3 4
0 0
0 0
0 0
0 0
1 0
0 1
0: OFF 1: ON
Function
Initial Normal Setting
Sorter Free Run
Staple Unit Free Run
Sorter & Staple Unit Free Run
Lower Staple Unit
Bin/Jam Sensor Adjustment
34
6 March 1992