Sensor Replacement - Ricoh FT8880 Service Manual

REPLACEMENT AND ADJUSTMENT

5.8 SENSOR REPLACEMENT

[G]
Stack Height Sensors
1. Remove the upper cover.
2. Remove the stack height sensor actuator [A] (1 screw).
3. Remove the bracket [B] (1 screw).
4. Replace the stack height sensor 1 [C] and the stack height sensor 2 [D].
NOTE: When reinstalling the bracket [B], align the edge of the bracket
with the stay [E].
Exit Unit Home Position Sensor/Exit Unit Half Turn Sensor
1. Remove the upper cover.
2. Remove the exit unit lift motor [F] (2 screws).
3. Replace the exit unit half turn sensor [G].
4. Remove the bracket [H] (1 screw) and replace the exit unit home position
sensor [I].
[F]
[I]
[H]
[D]
[A]
34
5 June 1992
[E]
[B]
[C]