Ricoh FT8880 Service Manual page 40

5 June 1992
[B]
18. Connect the operation unit [A] to the operation unit stand [B] (4 screws
and 1 connector).
19. Install the operation unit (1 M5 x 8 screw [C] and 1 connector [D]) and the
operation unit stopper [E] (2 M5 x 8 screws). The oval hole [F] of the
operation unit stopper should be at the lower position.
NOTE: 2 height positions of the operation unit can be selected by the
•
positions of securing screw [C].
The operation unit can be moved left to right by removing one
•
M5 x 8 screw [C] when the operation unit is mounted at the
lower position.
20. Secure the grounding wire [G] of the operation unit (1 screw) and reinstall
the right rear cover.
21. Set the drum guide [H] to the lower inner cover.
[E]
[F]
[C]
[D]
[A]
[H]
3-9
INSTALLATION PROCEDURE
[G]